This sweet wolf is ready to join your pack! He’s so wiggly, he’s impossible to put down. Print profiles provide for both an AMS-compatible coloured version and a single-colour version.

Behind the model

I sculpted this model with Nomad3D. The colouring was also done in Nomad3D to test the latest BambuStudio update allowing vertex painting.

The printed models used eSun PLA+ in White, Grey and Black.

Printing tips:

I recommend adding supports under the chin as the angle is a little bit sharp. These supports are pre-painted in the 3MF file.

If using PLA in an enclosure, keep the door open to help with cooling. 

It’s possible the pieces may stick slightly when printed. If this happens to you, press them firmly into each other to break any loose attachments.

If printing the multicoloured versions, make sure your flush volumes are fine-tuned.

Layer nozzle: 0.4mm

Layer height: 0.1 or 0.2mm

Perimeters: 2-3

Infill: Gyroid 8-10%