I tried to make the “sliding section fidget cube thingy” that had a few versions pop up lately… but i wanted it to be parametric.
attached is a FUSION 360 file for you to mess around with and get custom sizes!
NOW IN KEYCHAIN SIZE!
(note the paramaters comments. to change parameters go to: MODIFY>CHANGE PARAMETERS>EXPRESSION)
The print i showed was done with PLA altho i would reccomend PETG since it slides better…
Make sure your bed adhesion and overhangs are on point! you could probobly get away with 0% cooling thanks to the looooooong layer time
--------------------------------------------------------------
P.S
if the sections move with too much friction, a solution i found it to WASH the print in water, while sliding the sections back and forth.
Â
Congratulations to Gunny 3D for winning the 15*15 challange!
Honourable mention goes to Scott Yehle for his print!
Parametric Sectioned Cube
by Dror Yogev · original on Printables ↗
Toys & Games / Other Toys & Games
♥ 787⬇ 4.9k🖨 39 prints
Print profiles
sectioned cube 3X3.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
sectioned cube 4X4.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
sectioned cube 5X5.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
sectioned cube 6X6.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
sectioned cube 4X10.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
sectioned cube 15X15 if ur crazy lol.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
sectioned cube WITH LOGO.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print