Disclaimer: this model is not mine*, I downloaded it from this page where you can follow further instructions in order to paint it and customize it to be closer to the original model - https://ytec3d.com/pip-boy/

Other than that, this model has been scaled to fit a samsung galaxy S22.

Parameters:

infill: 35%, cubic/gyroid;
layer height: 0.2mm; 0.15mm for the wheel only;
supports: snug; 30° threshold angle;
brim: i used 20mm for the bigger parts, faceplate excluded.;

*all credits go to dragonator

PipBoy 3000

by MrGira · original on Printables ↗

Costumes & Accessories / Cosplay & Costumes in general

♥ 531⬇ 1.5k🖨 3 prints

License: Creative Commons — Attribution — Share Alike ↗falloutpipboys22pipboy3000

Print profiles

wheel.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
knob.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bracelet_back.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bracelet_front.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
latch.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Pipboy_full_Resized.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Face_Assembly.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print