Print in place satisfying clicking fidget that will keep you entertained for hours.

Tested on kids with success. :)

Print with no supports, the gear face down.

0.16 or 0.2 mm layer height and 0.4 mm nozzle.

Infill 35% or higher to ensure the strength of the gear is optimal.

Be gentle getting off the bed.

Tolerance for the gear is 0.1mm on each side, you need to carefully release the gear once done. 

Attached pictures are from print made on Bambu X1C using Silk dual colour filament, printing time under 30 minutes with 13g of material. Top and bottom pattern Octagram Spiral, infill Crosshatch.

Enjoy