AICS magazines are outragously expensive so I decided to make my own 3d printable version.

I have a christinsian arms MPR this uses short action AICS pattern magazines.

I modeled this magazine off a christinsian arms magazine. This should fit any gun that uses the AICS standerd.

ASSEMBLY:

After printing all the parts I used a spring from an old hex mag. I cut the spring in half and stuck it in my magazine.

1-flip the housing over to see the bottom

2-insert the follower

3-insert the spring

4-insert the base lock

5-press the base lock and slide the base until the rectangle clicks into place

AICS Short Action Magazine

Sports & Outdoor / Outdoor Sports

♥ 28⬇ 538🖨 1 prints

License: Creative Commons — Attribution — Noncommercial ↗diy565mmmagazinesavage30865browning65creedmooraics5roundchristinsianarmsaccuracyinternational

Print profiles

base plate.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
base lock.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Follower.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
housing.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print