if when you print the dragon and there is a error in print cut off the chain with the error and then to connect the chains back together cut the horizontal chain so there is a small gap where you put the vertical chain and it should be connected (please note this is a solution for petg users only because of petgs strong and flexible properties) and if you wait for the v2 there hopefully will have no errors
- use supports at 0% angle
- be careful this thing is so sharp so don't use it as a weapon
crystal dragon
by Layer by Layer Tech · original on Printables ↗
Toys & Games / Other Toys & Games
♥ 108⬇ 1.3k🖨 6 prints
Print profiles
crystal dragon.stl.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
crystal dragon V2 improved no errors at least of I know.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
low trangle no support version of V2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
V3 fixed version of V2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print