This is a little “bait can.” It's about 58mm tall and 100mm diameter. The lid has holes in it for the little wormies.

I have also included an alternative lid (shown in orange) that is a little easier to operate, and has larger/more ventilation holes. Both lids work with the same can, but the alternate lid is functionally better. The main lid (shown in pictures of gray bait can) was a test lid, and I liked the way it looked. In the pictures, the gray model was printed in PLA, and the orange model was printed in PETG

No supports required.

I printed mine with a 0.2 layer height. Print with 3-4 walls for some added strength.

Can of Worms (Bait Jar)

by Doug Kremer · original on Printables ↗

Sports & Outdoor / Outdoor Sports

♥ 204⬇ 831🖨 6 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗cancontainerlidfishingbinjarthreadedbait

Print profiles

Lid.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Can of Worms.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Alternate Lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print