Update:
for a new version of this model, including other sizes, gridfinity top and bottom and solid walls, please visit https://makerworld.com/en/models/1234733
Introduction
A remix of the gridfinity 5x3x5 (3 drawers) case (Hugo's version of Chipp Walters) with a honeycomb pattern. Thanks to Hugo for providing fusion360 file for the case.
It is also an improvement over souldbrotherb's since the honeycomb is aligned such that there are no horizontal overhangs, which improves the quality of the honeycomb.
The drawer can be used as a 5x3 carrier of gridfinity bins.
The drawer is a bit stronger than the case. There are significant filament savings compared to the original case and drawer. The case requires 221g and the drawer 45g.
Printing the case requires a well calibrated printer/filament.
I have printed them with 3 walls, using PLA.
Compatible with the original drawer pull (and it does not protrude inside the drawer)
Gridfinity Modular Drawer System and Case with honeycomb walls
by 駄目g · original on Printables ↗
Hobby & Makers / Organizers
♥ 1.1k⬇ 2.9k🖨 3 prints
Print profiles
gridfinity-drawer-system-drawer-honeycomb.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
gridfinity-drawer-system-case-honeycomb.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
gridfinity-drawer-system-case-honeycomb-alternate.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print