This printable side-release snap buckle has been designed so that both sides print flat on the print bed, which allows the layer lines to be optimally oriented to create an impressively strong functional buckle. Â
Carefully designed so that no supports are needed, and versions to support standard straps of three different sizes are included. Â Specifically strap widths of: Â 2 cm (.75 inch), 2.5 cm (1 inch), or 3.2 cm (1.25 inch). Â The version shown in most of the featured pictures is the 2.5 cm version. Â Works well in PLA, but PETG is even better.
Strong Printable Snap Buckle
by squinn · original on Printables ↗
Sports & Outdoor / Outdoor Sports
♥ 9.8k⬇ 20.5k🖨 273 prints
Print profiles
2.0 cm - Side A.stlIN STOCKDEFAULT
⏱ 12m · 5 g · 53 × 32 × 10 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
3.2 cm - Side B.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
3.2 cm - Side A.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2.5 cm - Side B.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2.5 cm - Side A.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2.0 cm - Side B.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print