Trash Can with separate Lid or as a Solid Model
Original design for the 2024 Christmas Community Print Drive.
Two versions are included: Solid Model and Bottom/Lid version with two parts. My kids insisted that I create the design that opens after I started with the solid version. The lid prints without supports by bridging across the opening that goes around the brim of the open can.
More Models: Collection of all approved 2024 Christmas Community Print Drive models
More Options at Cults3D: Trash Can Fidget Clicker & Nesting Trash Cans
Additional Information and Print Settings
The model is approximately 55 x 55 x 71 mm. I printed with 0.25 mm layer height, 2 perimeters, 3 top and bottom layers, and 15% infill. No supports. No raft.
If you are printing for the Community Print Drive, be sure to use the appropriate guidelines: |
More of my designs on Cults3D: https://cults3d.com/@abbymath
Not for commercial use. No derivatives. See license below.
Note: Most photos from earlier, smaller model. Print Drive standard models are posted here.
Trash Can
by abbymath · original on Printables ↗
Toys & Games / Other Toys & Games
♥ 419⬇ 2.9k🖨 25 prints
Print profiles
Trash Can Lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Trash Can Bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Trash Can Solid.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print