To assemble just look at the second picture, you print two cores, sandwich them together, put the sleeve over it and punch the pin through and then once its on the rail you can put the joined pins in to hold it in place
Hardware free vertical foregrip (Picatinny)
by Bruce LeedleLeedleLeedleLee · original on Printables ↗
Sports & Outdoor / Outdoor Sports
♥ 165⬇ 610🖨 20 prints
Print profiles
PumpSleevePin.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
NewPumpGripPin.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2PumpCore.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PumpSleeve.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PumpSleeveLOOOOONG.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print