A 2-in-1 device. Allows you to fill the chamber of your vaporizer with the funnel, and/or press a strong and dense pellet.

Normally, due to the low density, a small amount of 0,10 g would totally overfill the chamber, leading to muted flavor and burned herb (see pictures).

With this device, you can get up to double or three times as much into the chamber.

Also, less mess due to the funnel! :D

---

How to use it:

Step 1: Click the disk onto the funnel.

Step 2: Fill the funnel with your ground up weed.

Step 3: Press the bolt into the pile. Put the apparatus onto a solid surface, e.g. a table, and press hard.

Step 4: Repeat, until the tube is full.

Step 5: Remove the disk, and place the tube onto the chamber. Press the bolt, and the pellet should jump into the chamber. You can let it fly into your hand too of course.

Printing instructions:

• It's tightly fitting, with not many tolerances.
  • Your printer has to be accurate and calibrated properly.
  • You can change the tolerances in your slicer. 
    Mine was accurate, so I didn't have to change anything. 
    If it doesn't fit, change to “Exclusive” instead of “Middle”.
• I printed mine with PLA, and it was robust. Vapor polishing would make it even better. Consider printing it with PETG for more robustness.

Doesn't fit?

I designed it specifically for my Dynavap vaporizer. 
If it doesn't fit into the chamber of your non-Dynavap vaporizer, you can always modify the original file: https://cad.onshape.com/documents/995af95dcadd9b587a2b7a40/w/2e97ffbaba65dc11083f2425/e/00a45345b6f22e9c84f51996