I need hinges for the Laser Cut Stackable 3D Filament Holder I am designing. Â I had a set of small metal hinges that I used for the prototype, but no idea where or when I bought the originals so I designed these hinges in Fusion 360.
The model is made up of two parts that print in a single STL file and work right off the print bed. Â No supports are needed.
Two versions are available depending on the fasteners you will use:
- print-in-place hinge v11 - for flat bottomed screws or bolts
- print-in-place hinge v11 countersink - for wood screws expecting a counter sunk hole
Both #6 and #8 screws fit, the length depends on what you are attaching them to.  For my filament holder made of 1/8" board, I'm using #6-½" with washers and nuts.
For other print-in-place hinge sizes, check out my collection: EcoDad's Print-in-place Hinges Collection.
Print-in-Place Simple Hinge (no supports needed)
by EcoDad · original on Printables ↗
Hobby & Makers / Mechanical Parts
♥ 752⬇ 2.7k🖨 13 prints
Print profiles
print-in-place hinge v11.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
print-in-place hinge v11-countersink.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
print-in-place parameterized simple hinge v4.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print