While slicing, I used supports for the SD card slot and the screw holes but it's possible they may not all need supports.
After printing, poke holes through the thin top layer that is covering the screw holes.
Use care when adding the lid to not pinch the active cooler wires.
Original Author: @jeraff24_382585
Raspberry Pi 5 Case
by Bobby Greenan · original on Printables ↗
Gadgets / Computers
♥ 298⬇ 2.1k🖨 28 prints
Print profiles
pi5-case-base.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
pi5-case-lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print