I printed it in PETG with 40% gyroid infill and 4 perimeters and he “rubber interface” in TPU 95A with 2 perimeters and 20% infill.
The rubber interface is a nice touch but definetely not required.
If you have a round adhesive bumper pad (such as these ) you can use that instead of printing the rubber interface

Lian Li O11 Dynamic GPU anti-sag for bottom fans configuration

Gadgets / Computers

♥ 80⬇ 732🖨 5 prints

License: Creative Commons — Attribution ↗casefangpulianfanssaggpusupportlianlivideocardantisagantisagginggpuholder

Print profiles

lian_li_o11_dynamic_gpu_antisag_rubber_interface.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
lian_li_o11_dynamic_gpu_antisag.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
gpu_antisag_base_tall.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print