Special thanks to @sugarballs for the Idea!
Summary:
There are various version of this angled (15°) shotgun shell holder / side saddle available.
On the uploaded picture (Maverick 88) I used the 12G_5pcs_25mm_angled_velcro version. As Filament I used Prusament PETG with Carbon Fibers (Black).
Check the Key below to select the correct model for your shotgun:
| 12G_4pcs_25mm_angled_velcro | 12G = Caliber (12 Gauge) 4pcs = Capacity 25mm = Width angled = Shell direction/position velcro = Mounting |
Note:  The angle is 15°.
Printing instructions:
Use PETG
Perimeters: 3
Solid layers Top & Bottom 5
Infill: >35%
No Supports
Note: Place the shell holder on the heat bed in the same direction as you would mount it.
Fastening:
Velcro Strip
(I used tesa On&Off extra strong)
Note: Use the “Loop”-side (German: Flauschband) on your gun and the “hook”-side (German: Haftband) on the holder.  Btw: loop is the soft side, hook is the harder side of the velcro strip.
Outro:
The shell fit is quite tight and needs to wear in a little. Let me know about yours!
Happy printing and let me know if you need further information or instructions.
Angled shotgun shell holder / side saddle (12 Gauge)
by Theroux · original on Printables ↗
Sports & Outdoor / Outdoor Sports
♥ 119⬇ 707🖨 2 prints
Print profiles
12G_3pcs_25mm_angled_velcro.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
12G_2pcs_25mm_angled_velcro.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
12G_4pcs_25mm_angled_velcro.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
12G_5pcs_25mm_angled_velcro.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print