If you're looking for my Bambu print profiles, they're at MW. If you're looking for my Bambu print profiles for version 2, they're here.

Update (10/2025): There is now a version 2 of the Plant Stem Support! Now this doesn't mean this original model is worse, just different, so take a look to see which you prefer. 

Plant Stem Support Holder (Many Sizes)

A simple support designed to help weak or leaning plant stems stay upright without tying or clipping the plant.

The holder rests on the soil surface and gently cradles the stem, providing support while still allowing the plant to grow naturally.

Multiple sizes are included so you can choose the support that best fits your plant and pot.

Features

• Gently supports plant stems without squeezing or damaging them

• Multiple sizes included to accommodate different plants

• Center hole for optional support rod or stake

• Lightweight design that rests directly on the soil surface

• Simple geometry designed for clean FDM printing

The open design makes it easy to place around an existing plant without disturbing the roots.

Printing Notes

• No supports required

• Prints well at 0.20 mm layer height

• PLA or PETG both work well

• Low infill (10–15%) is usually sufficient

Because the holders are small and lightweight, they print quickly and use very little filament.

Good Uses

• Supporting young seedlings

• Stabilizing leaning houseplants

• Helping plants recover after repotting

• Supporting top-heavy stems