Ethernet cable fix which prints WITHOUT SUPPORTS. The layer line orientation aids in keeping the cable in the port.
Print settings:
- layer height 0.2mm
- 3 thick walls
- Infill: Does not matter since the piece is too small to even have infill
- Material: PLA/PETG
- NO SUPPORTS
- NO ADHESION, except a skirt if necessary
Ethernet RJ45 repair fix with NO SUPPORTS
by Carletes359 · original on Printables ↗
Gadgets / Computers
♥ 412⬇ 2.1k🖨 19 prints
Print profiles
EthernetRepair.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
EthernetRepair.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print