I had seen a set of pallet coasters but wasn't quite happy with the model, so I fired up Fusion and recreated to spec a GMA pallet, then scaled it to about 1:11th (3.5:40). Found it would actually slice quite nicely at 0.20mm height, so I roughed out a hand truck to hold 'em and sent it. It's adorable 😄
Print two of the load wheels, one of everything else, and as many coasters as you'd like (four fit nicely on a 250x250 bed). I printed the coasters face-down and did a little manual support painting down the middle of the runners so as to only add a little time and material and still get a clean result. The Truck body requires a little support for it's butt. Print the wheels on their sides and add a little support under the block for the steering wheel.
Glue the bits to the truck and you're done!
Tuned print profiles available over on Makerworld.
GMA Pallet Coasters and Hand Truck
by RevHazlett · original on Printables ↗
Household / Kitchen
♥ 481⬇ 1.1k🖨 4 prints
Print profiles
Load Wheel.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
GMA Pallet (1-11th scale).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Handle.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Steer Wheel.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Truck Body.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print