Easy to print wall mount for the new Unifi Cloud Gateway Ultra.

Print orientation is laid flat.

• 3 wall loops
• 20% infill (I prefer gyroid)
• 0.20mm layer height
• Supports required on the overhang

Inspiration for this model comes from another model published on Printables, but the creator does not allow remixes, so I created this from scratch with Shapr3D.

Rev 2

Added an additional model with an extra mounting hole to better secure the mount, should you wish to fit this under a shelf or desk.

I have also released another mode, which allows you to mount under a desk or shelf, whilst keeping the correct orientation of the UCG. Currently if you use the wall mount to mount under a desk or shelf then the UCG would be upside down.