As seen on YouTube:

Dayton Audio ND25FA-4: https://www.parts-express.com/--275-059

Dayton Audio TCP115-4: https://www.parts-express.com/--295-415

Dayton Audio XO2W-3K: https://www.parts-express.com/--260-144

Screws: https://www.parts-express.com/--081-435

Epoxy the drivers firmly into their insets. Remember to seal all 4 mounting holes around each driver. (Blu-Tack works.) Space the crossover away from the mounting rails with Blu-Tack to prevent vibration. Run a thin / wide gasket of Blu-Tack around the rear access opening before screwing the backplate in to achieve a proper seal. Input below 40Hz is NOT recommended. (Exercise caution if no high-pass filter is available.) Recommended power: 40-80W per Dozer.

Disclaimer: This is an acoustic model. As such, it does not scale, nor is it compatible with drivers other than the ones specified. Scaling / incorrect driver(s) will result in significantly diminished performance.

HexiBox Series: Dozer

by HexiBase · original on Printables ↗

Gadgets / Audio

♥ 156⬇ 1.2k🖨 6 prints

License: Creative Commons — Attribution ↗desktopaudiospeakerbookshelfwoofertweeterdayton

Print profiles

Dozer Backplate Vent.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Dozer Accent Shields (Dual Material Version).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Dozer Enclosure Body (Single Material Version).stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Dozer Enclosure Body (Dual Material Version).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print