I made them as close the to the original as i could.

Print orientation is important!
For best results i recommend to print them on the top-side surface (it's the shorter one).

If you print them flat they feet will break easily.

Material:

PLA is fine, if you print them upright like in the pictures.

Stronger materials like PETG or ABS will be better i guess.
I used PLA and PETG, both worked fine.

Printer:

I used a Bambolap P1S: 0.20 mm layer height or 0.08mm are both really good.

A Resin printer would make even nicer parts, but i'm not sure about the feet, maybe its to brittle.