The stand is designed to hold all versions of the Apple Watch from the SE to the Ultra. Accents on the front & back are printed separately and can fitted in after being printed.
Recommended that you use my print profile, but if not make sure Arachne wall generator is selected for both the stand and Accents
Accents are a tight fit so position them into place and push down on a hard flat surface for a flush fit.
O.4mm Nozzle
Recommended 0.2mm Layer HeightÂ
10% Infill
May need a brim for accents and tree/organic supports for charger cutout
Apple Watch Charging Stand (No MMU or AMS Needed)
by Reckit · original on Printables ↗
Gadgets / Other Gadgets
♥ 276⬇ 1.3k🖨 20 prints
Print profiles
Apple Watch Stand.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Front Accent.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Back Accent.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print