Holder for a CR2032 coin cell batteries.

Battery is securely held in place
Single (3V), double (6V) and triple (9V) versions
Designed for use with breadboard jumper/dupont wires or bare wire
Total holder thickness is 7.3mm for the single cell holder, 10.5mm for the double and 13.7mm for the triple
Support free print

CR2032 Coin Cell Battery Holder

Hobby & Makers / Electronics

♥ 617⬇ 2.4k🖨 29 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗supportlessbatterycr20322032batteryholderdupontjumperwirecr2032batterycr2032batteryholder

Print profiles

CR2032 Holder Double (6V).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
CR2032 Holder.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
CR2032 Holder Triple (9V).3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
CR2032 Holder Triple (9V).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
CR2032 Holder.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
CR2032 Holder Double (6V).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print