Tornado Foosball Guy
A foosball replacement guy based on Tornado brand foosball tables. If you plan to use this on a foosball table, print with a large percentage infill with a strong material. These guys take a lot of abuse.Â
Tornado brand foosball rods are slightly smaller diameter rods (15.7mm) than less expensive foosball table models (typically 15.9mm). Tornado tables also have a roll pin to attach the guy to the rod while less expensive tables typically use a bolt and nut. I have added bolt and nut versions with a larger diameter rod hole, if you do not have a Tornado table.Â
I printed the original version at a compound angle  and upside down to reduce tree supports on critical areas like the rod hole. The support tree that enters the rod hole is supporting the roll pin hole. See images.Â
Good luck - reach out if you have issues or questions.Â
Tornado Foosball Guy
by ShopTeacher · original on Printables ↗
Sports & Outdoor / Indoor Sports
♥ 27⬇ 547🖨 2 prints
Print profiles
Foosman Printer Friendlier - 0.625in Rod - 8-32 Hex Back.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tornado Foosman Original v1.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Tornado Foosman Printer Friendlier v1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Foosman Printer Friendlier - 0.625in Rod - 4mm Hex Back.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print