Te used with the www.multiboard.io system
A small and strong screwable hook to be used in the Multiboard pegboard holes. The hook is printed sideways to make it very strong.
Orientation
The orientation of the hook will vary depending on how you installed your multigrid, especially for squared ones as they can be installed in any of the 4 orientations.
To find out which hook you need (for each board) just print 4 of them to test (#1, #3, #5, #7) and find out which one points up for each board :D (I have uploaded a test print for this purpose).
I put numbers on the back of each hook for printing reference, just note that the 1 is not always “up” but it's just a starting reference for the rotation.
PS: I also added a few more hooks with halfway rotation in case you need them (#2, #4, #6, #8).
Multiboard Hook Pin
by Kunzite · original on Printables ↗
Hobby & Makers / Organizers
♥ 488⬇ 3.0k🖨 33 prints
Print profiles
(Bonus) Hookable holder - By Kunzite.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
(Short) Multiboard Hook - All orientation - by Kunzite.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
(Print this first) Test print to check orientation - by Kunzite.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
(Long) Multiboard Hook - All orientation - by Kunzite.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print