I recently received the NVME Base by Pimoroni for my Raspberry Pi 5. I noticed that there are only a few cases which accommodate it. I was sure that I could remix a nice case to change that. Here it is…
Update: Added different bottom shell for NVMe Base Duo (long term usage not tested)
A Pimoroni NVMe Base Duo was kindly provided by RaspberryStore.nl , as a reference.
#HowTo Print
Place the halves of the case with their largest flat side facing towards the print-bed. The material is your choice. I simply used PLA. I used 0.15mm Layers but everything ≤0.2mm should work.
#HowTo Assemble
- Install the NVME Base to your Pi by following Pimoroni's installation-instructions (https://youtu.be/odG7FbptgWQ).
- Insert the assembly carefully into the bottom shell with the NVME-base facing down and the micro-SD-slot facing its designated opening.
- Snap fit the top and you are done! 🎉
Raspberry Pi 5 + Pimoroni NVME Base Case
by LUC4R4T0R · original on Printables ↗
Hobby & Makers / Electronics
♥ 209⬇ 2.4k🖨 31 prints
Print profiles
top.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
top_ribbon.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
top_THRML_60.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
top_ribbon_gpio.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
top_gpio.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bottom.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
bottom_duo.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print