The original box for the iFixit Mako Driver Kit is held closed by magnets. However, if you often carry the toolkit around, this extension might be useful to you, making the box closable with a latch.
All parts are printable without supports. The recommended material is PETG. The latch is attached to the frame with a paper clip.
This model was created by designer Michal Fanta.
iFixit Mako Driver Kit box frame
by ifixit · original on Printables ↗
Hobby & Makers / Tools
♥ 2.1k⬇ 4.0k🖨 73 prints
Print profiles
ifixit_mako_top_pads_4x.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
ifixit_mako_bottom_pads_4x.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
ifixit_mako_latch_1x.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
ifixit_mako_frame_1x.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print