Remix of the enclosure designed by @mdkendall for the ESP32 Cheap Yellow Display (ESP32-2432S028R) found on Aliexpress & similar sites.
Model adjusted for the USB-C board version, which does have slight variations of the connector positions (especially mounting holes & USB-C connector).
Note: Self-tapping version only
Print settings
- Material: PETG
- PLA should be fine as well, probably with less flex on the buttons. The board gets warm on the back, but I don't think it's that warm to melt PLA.
- 0.4mm nozzle
- 0.2mm layer height
- 3 walls
- 2 is probably fine as well
- 15% infill or more
Required hardware
- 4x M3x6 Socket Head screw (self-taps into plastic)
ESP32 Cheap Yellow Display (USB-C version) Enclosure (ESP32-2432S028R)
by Michał · original on Printables ↗
Hobby & Makers / Electronics
♥ 120⬇ 1.6k🖨 15 prints
Print profiles
full_case_v3_1_0__generic.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
front_v3_1_0_self_tap.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
back_v3_1_0.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print