I printed the gargoyle with Overture Rock PLA. I then glued the gargoyle to the bracket (printed in black) and attached to the corner of the monitor with a small 3M Command Strip. I put one on each corner (see photo).I used organic supports and a 10 mm brim on the gargoyle. The bracket does not require supports (position the long side of the bracket on the build plate).

Monitor Gargoyle

by mhparsons · original on Printables ↗

Household / Office

♥ 269⬇ 1.2k🖨 13 prints

License: Creative Commons — Attribution — Share Alike ↗decorationstatuemonitorgargoyle

Print profiles

Bracket-Monitor Gargoyle-v1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Gargoyle-Monitor Gargoyle-v2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print