Designed this case with a snap-fit lid to fit a 38 pin ESP32 breakout board, you'll find these all over aliexpress/ebay/amazon, etc.
The case has symmetrical cutouts to access the terminals on either side, so you can mount the board in any orientation. You should also be able to access the usb-c/micro-usb port whilst the lid is off, without needing to remove the board from the case. The board can be screwed into the case leveraging some heat set inserts and 4 bolts.
I am personally using this mounted with some double-sided 3M VHB tape.
Required hardware:
- Heat set inserts: M3 x L6 x D4. Maximum length can be 7mm, this is just what I used.
- 4 x bolts: M3 x 8mm
- Optionally, some double-sided tape to mount it.
Printed this model? Show the community what it looks like by posting your make.
ESP32 38 pin breakout board case (snap-fit lid)
by Reitangle · original on Printables ↗
Hobby & Makers / Electronics
♥ 38⬇ 1.0k🖨 1 prints
Print profiles
ESP32-breakoutboard-case.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
ESP32-breakoutboard-lid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print