A voronoi skull designed to print perfectly and not require too much support.

It is prints on its nose and only requires a bit of support on its eyebrows and forehead, this can be painted on in most software but if you can't or don't know how to paint on support you can just use my g-code provided(100mm/s, 0.2mm layer height) If your buildplate adhesion is no very good I would recommend printing it with a brim (I will also provide a g-code for this)

You can scale it up or down as much as you like, and I found that if you scale it below 50% you can print the whole thing without any support! Though be careful because this may not work out for you depending on your printer.

Enjoy!