If you own more than one bike with a SRAM AXS groupset, you may have accumulated a few of the single battery chargers (EP-EAC-BC-A1) like this one:

The individual chargers are very light and the cables tend to cause them to slide around and not want to sit flat on a table.

This is a simple, press-fit model that let's you group several together and wall mount or just organize more easily. This should snuggly fit the EP-EAC-BC-A1 model chargers. I doubt it will fit any of the aftermarket chargers.

Combined with a multiple USB-A to Micro-USB cable, you can very neatly organize a wall mounted charging station without spending $120 on the 4x SRAM single charger.

Printing Instructions

• Flat side down
• 0.2mm layer height
• 3 walls
• 15% gyroid infill
• Any material should be fine, mine is Matte Black PLA

Installing/Removing

If you printer tolerances are good, you should be able to push the non-charger end into the mount first and then press the charging side down with a small amount of force. It should be tight enough that it won't easily fall out.

You can remove it by lifting under the charge port.

You can scale up or down if it's too tight or loose, I printed mine on a Bambu X1C in PLA and it's nearly a perfect fit as-is.

Each model has countersunk screw holes for mounting to the wall. Just make sure the screws you use don't protrude too far or the charger won't fit down all the way.