A hard case for the R36S retro gaming device. The case was designed to allow the buttons, joysticks and screen ample room inside the case. There is room to glue in a thin piece of felt above the screen for added protection.
There are two variants, one using 8x3mm magnets and another that uses a simple latching mechanism. The hinge fits a small length of filament.
The cases seen in the photographs were printed in Bambu ABS without supports with a 5mm brim at 0.20mm.
Edit: Fixed the latched .3mf file, and added .STL versions
R36S Retro Handheld Hard Case
by stumpagness · original on Printables ↗
Gadgets / Portable Devices
♥ 150⬇ 1.2k🖨 18 prints
Print profiles
R36s Hard Case - Magnetic.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
R36s Hard Case - Latch.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
R36s Hard Case - Magnetic.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
R36s Hard Case - Latch.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print