I printed with 15% infill and 0.18mm layer height and it came out great.

After printing the model, super glue little magnets in the holes in the corners to make the pieces snap together. (I used mini 4x2mm magnets) There's a compartment for wheels and bushings as well as a holder for a fingerboard tool.

32mm Fingerboard Case

by BSBLKID · original on Printables ↗

Sports & Outdoor / Indoor Sports

♥ 39⬇ 567🖨 0 prints

License: Creative Commons — Attribution — Noncommercial ↗casefingerboardfingerboarding

Print profiles

Fingerboard Case 32mm.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print