I liked the DRIDER 13 remix so much I printed it at 300%. However it looked a bit bare with just black spider parts, so I designed some armor pieces for it.
The three ‘Leg’ pieces need to be printed per leg, so eight times
Abdomen once, and Palp twice.
These are at 100% scale, adjust to your model. I didn't test it at smaller size, and while I observed the thickness used in Dummy 13, chances are they'll be fragile. I would recomment PETG or ASA for that reason, rather than PLA.
DRIDER-13 Armor Pieces
by prusieck · original on Printables ↗
Art & Design / Sculptures
♥ 617⬇ 1.4k🖨 8 prints
Print profiles
Leg C.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Leg B.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Abdomen.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Leg A.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Palp.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print