This is just an alteration of an existing can dispenser, in order to make it fit the standard 375ml Coca-Cola can in AUS. I also adjusted the size and length of the ramps to give the can enough clearance to fit under the top shelf.
Update 07/01/24 - I had not realised that I uploaded an earlier test model file for the RearRight.stl that was missing a cut-out for fitment. This has been fixed! (─‿─)
Can Dispenser (375ml/Aus size)
by Bones · original on Printables ↗
Household / Kitchen
♥ 746⬇ 2.0k🖨 2 prints
Print profiles
RearLeft.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
RearRight.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
FrontLeft.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
FrontRight.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print