This is a case for Raspberry Pi 5 supporting official fan as well as unofficial fan.
Supported cooling configurations
This case supports following variations in terms of cooling.
- No fan
- Official fan
- Unofficial fan (40x10), eg. Noctua NF-A4x10Â
- To power it from GPIO, relatively short header pins are needed (12mm or shorter).
Models to Print
There are a bottom model and 2 lid models.
- Pi5 Bottom (common to all configurations)
- Pi5 Lid (for no fan or official fan)
- Pi5 Lid Fan 40x10 (for no fan or unofficial fan)
Depending on your configuration, please print this way.
| Configuration | Bottom Model | Lid Model |
|---|---|---|
| No fan | Pi5 Bottom | Pi5 Lid |
| Official fan | Pi5 Bottom | Pi5 Lid |
| Unofficial 40x10 fan | Pi5 Bottom | Pi5 Lid Fan 40x10 |
Updates
(11/26/2023) Updated “Pi5 Lid Fan” for better fan fitting.
(06/10/2025) Fixed a bug in camera cable slit where it was too narrow for official cables. It was ok for 3rd party narrow cables though. Thank you @diedhert_62410 for the feedback!
Pi5 Case (+Official/Unofficial Fan)
by ywabiko · original on Printables ↗
Gadgets / Computers
♥ 39⬇ 788🖨 5 prints
Print profiles
Pi5 Bottom v14.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Pi5 Lid v40.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Pi5 Lid Fan 40x10 v17.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print