Thissimple mod replaces the top part / lid of yesimjess' Paintbrush cleaner. I found the screw-mechanism quite timeconsuming. So I replaced it with a leaf spring and push button assembly.
No additional hardware is needed for assembly. The leaf spring is secured in place using to short pieces of filament.
In regard to the license: This remix has to use the same license as the original model. Non-comercial use of the original (and therefore this model) is prohibited. In some areas this will exclude educational use as well. The use of this model for educational purposes is explicitly allowed.
Water Dispensing Paintbrush Cleaner - Push Button Mod
by MacNite · original on Printables ↗
Tabletop Miniatures / Miniature Gaming Accessories
♥ 835⬇ 1.6k🖨 19 prints
Print profiles
Leaf_Spring.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
reservoir (not modified - reupload for convenience).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
PushButto.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Top_PushButton.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print