all available raisers had angles that were too wide for my liking. So I made one, it connects to the keyboard via slide rails, you can also flip it over to keep the keyboard upright when not in use.
Tilt the pieces towards the inside, as in the photo. Supports for angles up to 35°. Infill 20%.
I have included a middle part, with hole for lightning cable (optional printing)
Publish photos of your makes :)
Apple Magic Keyboard 2-in-1: Raiser and vertical stand
by Bennacerismo · original on Printables ↗
Gadgets / Computers
♥ 52⬇ 588🖨 7 prints
Print profiles
Left.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Right.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Center.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print