Hello!, this time I bring you the model for wall decoration to
"Luffy Gear 5" or "Luffy Fifth Gear" in 20 cm 2D.
You can print it in one piece or print it in 2 parts if it doesn't reach your printer (like my c':). You can also scale it.
Below I leave you the parameters with which I printed it but you can use yours and tell me how it went.
Enjoy printing.
Parameters
- Layer Height and Initial Layer: 0.2 mm
- Horizontal Expansion: 0.12
-Infill: 15%
- Fill Pattern: Lines
-Bed temperature: 55 °C
-Print speed: 50 mm/s (attached an image with the speeds in more detail in the carousel) It is important that in the initial layers they are of low speeds to achieve good adhesion.
-Support: No
Luffy Gear 5 - One Piece 2D
by RaveCrown · original on Printables ↗
Art & Design / Other Art & Designs
♥ 270⬇ 2.2k🖨 6 prints
Print profiles
Luffy Parte 2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Luffy Parte 1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Luffy 2D.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print