I made this simple model of a Ski Rack. The intended use is to hang skis quickly on the wall of a house/cabin/shed (or whatever). The rack is screwed to the wall, and the skis hang from the ski tips.

Prints without support!

Lay the model flat (as shown in the picture) to have the layers in correct orientation for strength. Use a lot of walls! (minimum 8-10).

Those shown in the picture will be covered by a door, so they wont be in the sun. Therefore I printed them in PLA. You choose material according to where they will be used. For outdoor use ASA might be a good choice.

I have made 3 different models, each with different distance between the bars. 10mm, 15mm and 20mm width.

10mm width for cross country skis

15mm width for down hill skis

20mm I added for good measure :)

EDIT: By request, I added an extra wide version with 50mm between the bars.

There is also a width tester for each size, so you can easily print this tester, with minimal use of filament, to check what size is correct for your skis.

Ski Rack - No supports!

by Erik · original on Printables ↗

Sports & Outdoor / Winter Sports

♥ 90⬇ 593🖨 5 prints

License: Creative Commons — Attribution — Noncommercial ↗snowwinterrackskicabin

Print profiles

SkiRack 10mm.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
SkiRack 15mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
SkiRack 20mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Width tester - tester 20mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Width tester - tester 15mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Width tester - tester 10mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Ski Rack - 50mm (Very wide version).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print