When I found out about the awesome Dummy 13 designed by soozafone, I had to print one or two and then I realised they NEEDED a Lighsaber. Used the staff from the original to make it.
This is at 200% so you'll need to scale down for the original size. I printed my Dummy 13 at 200%.
There is a Full Saber file which is the purple one in the photo and then I made a hilt and blade seperate so people can print the blade in Vase Mode and glue together which is how the blue one was printed.
I just changed colour at set layer heights. Make sure you use a brim.
Dummy 13 Lightsaber
by tgsparky77 · original on Printables ↗
Toys & Games / Action Figures & Statues
♥ 1.5k⬇ 5.7k🖨 21 prints
Print profiles
Hilt Only.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Saber End.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Full Saber.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print