A lot stronger than you might think. Print long way down.
I did have to hammer the pieces slightly and that's by design. You could use screws to secure the pieces a bit more but just by friction alone it should be fine.
Sturdy pieces that fit tightly to join two 2020 extrusions together.
Designed to print at a 0.2mm height.
2020 extrusion connector - inlet connectors
by Carlos Alberto · original on Printables ↗
Hobby & Makers / Tools
♥ 119⬇ 899🖨 4 prints
Print profiles
2020 - inlet connector_solid.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2020 - inlet connector_hexHoles.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2020 - inlet connector_simpleHoles.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print