I wanted a wall mount that would hold the Quest 3's controllers without risk of them slipping out or getting damaged.

Settings used:

Layer Height = 0.20mm
Walls = 3
Infill = 20%
Supports = On
Brim = On

Small amount of support required for the ends of the arms, may get away without support, but I would recommend them being enabled (example pictured)

I created this by approximately profiling around the Quest pro controllers to have a bespoke fit, so this will NOT fit the Quest 1 or 2 controllers (due to the rings and slightly different design).

There are 3 versions, one that has a screw mount (recommended), a riskier double sided tape mount (untested!) if you can't drill into walls etc. and one compatible with the Skadis T-Clip system.

Changes 16/10/23:

Added Skadis T-Clip mounting method

Headset mount: https://www.printables.com/model/615721-quest-vr-headset-wall-mount

Quest 3 Touch Controller Wall Mount

by Bengyboo · original on Printables ↗

Gadgets / Virtual Reality

♥ 232⬇ 1.6k🖨 33 prints

License: Creative Commons — Attribution — Noncommercial ↗wallmountcontrollervroculusquestmetaquest3

Print profiles

Quest 3 Controller Wall Mount - Sticky.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Quest 3 Controller Wall Mount.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Quest 3 Controller Wall Mount - Skadis T-Clip.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print