Screw claw to hold screws in front of the screwdriver.
Allows easy and one-handed screwing without the screw falling off the bit.

You can support me with a coffee: https://www.buymeacoffee.com/maxwxyz

Place the screw claw on the front of screwdriver / bit and insert the screw. Then tighten the screw as usual. The screw is held by the clamp and does not fall out, even upside down / over head.

The claw is available in two options:

Two-piece set for larger screws
One-piece claw for smaller screws

Print in PETG for flexibility. Remove stringing if necessary.

Schraubkralle um Schrauben beim Anziehen mit dem Schraubendreher oder Bit zu fixieren. Ermöglicht einhändiges Verschrauben, ohne ein Runterfallen der Schrauben.

Screw Claw for Screwdriver and Bits

by maxwxyz · original on Printables ↗

Hobby & Makers / Tools

♥ 1.8k⬇ 4.3k🖨 38 prints

License: Creative Commons — Attribution — Share Alike ↗toolwrenchholderscrewsmountdiybitbuildingbracketscrewboltscrewdriverboltsweraclawdriverschraubendreherfixationhalterschraubefixierungschraubenimpactschraubenzieherrepairsscrewingschraubhalterschraubkralleschraubenhalterkralle

Print profiles

Schraubenhalter-Schrauben-Grip.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Schraubenhalter-Bit-Grip.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Schraubenhalter-Schraubenhalter-Gesamt.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print