I decided to print this small model for holding my HONOR phone cable. Fits snug and is satisfying to use ( your mileage may vary :) ). Made in Fusion 360.
There are two versions. You decide which one you want to print :
- USB cable holder fillet.stl - is the original model, made for printing backside down. You might need some supports, but I have also printed it without them ( you will have to use pliers to remove overhanging pieces )
- USB cable holder standing.stl - is an alternate model, made for printing standing up. You may want to print this model to avoid any overhangs and supports. However, the bottom side is going to be flat, without a fillet.
USB-C Cable holder, organizer for desk / table
by KrafťákSvK · original on Printables ↗
Hobby & Makers / Organizers
♥ 205⬇ 2.0k🖨 7 prints
License: Creative Commons — Attribution — Noncommercial ↗tableorganizerholderdeskfidgetusbusbholderusbcusbcablesatisfying
Print profiles
USB cable holder standing.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
USB cable holder fillet.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print