…Please be sure to hit like & post a make, I'd love to see your prints!

 EDIT: Finally! STEP file has been added!! Sorry it took so long guys, enjoy!!

Add some class to your Voron with this awesome canopy / top hat!

If you have a smaller size printer use these corner models but the original models centre section linked under the description.

It adds a small but needed amount of extra room up top on your 2.4 for your Stealthburner's umbilical cable & Bowden tube enabling you to grab a few extra centimetres of printing height!

I have split the corner model, & added hidden M3 bolt & heat insert holes to attach parts together. I also flattened the backs of the corner & centre parts so they can be printed laying down halving print time for the same full corner parts & only requiring 5g of supports per corner! Bonus!

ADD NEOPIXEL LED'S TO YOUR TOP HAT!!!

https://www.printables.com/model/938251-voron-24-trident-canopy-top-hat-neopixel-led-mod-c

You'll need per corner:

2x Voron BOM M3 heat inserts

6x 8mm M3 Cap head bolts

6x M3 spinning T nuts

You'll need per centre section:

2x 8mm M3 cap head bolts

6x M3 spinning T nuts

>>>2x small length of Voron BOM 2.5mm thick Foam tape - each end to seal panels <<<

EDIT: Some people seem to not read the BOM list above properly & complain there's a gap between the centre sections & the corner parts & think the model is wrong. 

THERE'S SUPPOSED TO BE A GAP!!!

This is for you to add the specified FOAM SEALING TAPE between the parts TO SEAL YOUR ENCLOSURE so you don't get ABS fumes filling your print room.

PLEASE READ THE LIST ABOVE CAREFULLY, & don't leave a bad review because you missed the information about the foam tape, it's been there since the model was published & you can clearly see it in my original photos at the top of the page.

Printing:

Print left & right corner parts 1 & 2 twice each per machine.

Lay flat on the backsides as per slicer photo above. Be sure to put some support under the lips of all parts, & behind the Voron logo on the centre part.

Use standard Voron print settings & ABS/ASA.

But what about securing the top plastic panel I hear you say….

Well be sure to print some of these clips! No hardware required!

https://www.printables.com/model/594870-voron-24-trident-top-hat-top-panel-clips-no-hardwa

Want to add a good camera? Try this!

https://www.printables.com/model/594857-voron-24-trident-top-hat-logitech-c920-camera-moun

Please make sure your printer is set up well for this, the tolerances are very tight 0.1-0.2mm! Any less than perfect setup might cause the prints not to fit well or at all!

This is not a reason for a bad review, these models are known to fit perfectly. If you have trouble with the fit please adjust your print settings or seek some assistance with your print profile or mechanical setup.

Demon Klipper Essentials Voron Macro Pack!!

Do you need some cool new macros?

Check out my highly adaptive & automated macro pack! Suitable for most Klipper printers including your Voron!

Find my macro pack here!