Reversible TPU Door Stop to hold a door open or closed. The cutout pattern actually serves a purpose other than looking cool. It allows you to select a firm or flexible grip on the door depending on which orientation you use. If it is wedged under the door at a spot that is hollow underneath, it will squish and flex under the door. If you reverse it and flip to the other side to stop the door where the lines join, it will stay firm and won't flex as much. You may prefer one way or the other depending on your type of floor or door, or how tight of a grip you want. I attached pictures using it both ways on the same door. 

Print Settings

This model is intended to be printed in TPU. The flexibility of TPU will give the doorstop similar properties of rubber, and allow it to bend and flex while wedged under a door, and be soft enough to not scratch the door or floor.

Printer: AnkerMake M5

Filament: TPU

Infill: 10% Gyroid

Perimeters: 3

Solid Layers: 5 top, 5 bottom

Supports: No supports required

Layer Height: 0.2mm