This is a golf club (pitching wedge) with an approximate total length of 35cm. It can be used to hit real golf balls, but it's better suited for lighter toy balls.
—
It prints in three parts that need to be glued together:
- Golf club head: Can be printed on its leading edge without any support.
- Golf club shaft: With a length of 26cm, it fits diagonally on most print beds. Both ends need a little bit of support.
- Golf club handle: Can be printed upright, but might need a brim and lower print speed to prevent being knocked over.
—
Baby Golf Club
by Floern · original on Printables ↗
Toys & Games / Outdoor Toys
♥ 123⬇ 2.4k🖨 2 prints
Print profiles
golf-club-head.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
golf-club-handle.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
golf-club-shaft.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print